NC-studio

Welcome to use CNC router.
For safe operation and operation, please ground CNC router safely!
1. Grounding of CNC router body.
2. Grounding of control box of frequency converter.

1.Introduction of wiring of CNC router
Rear ends of control box of CNC router connect with X and Y (two pieces), Z, frequency
converter, limit switch and external power source (AC 220V) separately. Front panel
connects signal wire, another end of signal wire connects control panel interface on the
computer.
2. Install control software

After finishing wiring of engraver, we start to install control software of CNC router.
(ARTCUT software, graphic and text design software for engraver, has detailed description
on its software, so no further introduction is made here).
After finishing software installation, insert PCI control card into PCI slot of the computer.
After placing control software into CD-ROM, operate SETUP. EXE file for installation,

Press NEXT until finishing installation. Then turn off the computer and insert PCI control card into PCI slot of the computer. Start the computer again, the computer will automatically install driver program.

List of Shortcuts

1. Overall Overall shortcuts shortcuts

ESC Switchover between various windows

TAB Switchover between various controls

Ctrl+TAB Switchover between various folding windows

Ctrl+1 Display automatic window

Ctrl+2 Display manual window

Alt+1/F4 Display processing locus window

Alt+2 Display system lag window

Alt+3 Display program management window26

Alt+4 Display system parameter window

Alt+5 Display program edit window

Alt+6 Display I/O state window

Ctrl+Enter Fullscreen

Ctrl+Del Clear processing locus window

Ctrl+O Open and load

Ctrl+N New processing program

Ctrl+E Open and edit

Ctrl+P Edit current processing program

Ctrl+S Save Ctrl+I Processing program information

F5 Direct positioning

F6 Set coordinate of work piece at current point

Shift+F6 Set current point as base point of work piece

F7 Return base point of work piece

Ctrl+F7 Floating tool calibration

Shift+F7 Fixed tool calibration

F8 Enter (exit) emulation

F9 Start Ctrl+F9 Advanced start

Shift+F9 Break point continue

Ctrl+Shift+F9 Implement processing command

F10/Pause Break Pause

F11 Stop

F12 Reset

Comments are closed.

Request A Quote
✕

Login

Lost your password?